How to apply DTF transfers with a heat press

1. Prepare the press
   Preheat your heat press to approximately 149°C.

2. Prepare the garment
   Lay the garment flat, ensuring there are no wrinkles. Press the garment for 10 seconds to smooth the fabric and remove any moisture.

3. Position the transfer
   Place the DTF transfer with the smooth side facing up onto the garment. Ensure the transfer is correctly aligned before proceeding.

4. Apply heat and pressure
   With the transfer in place, press for 20 seconds using firm, even pressure.

5. Cool the transfer
   Remove the garment from the press and allow it to cool until it feels slightly warm to the touch. Test with your fingers to ensure it is no longer hot but retains mild warmth. Do not proceed if the transfer is too warm or completely cold, as this may affect the results.

6. Peel the transfer
   Starting from one corner, slowly peel the transfer backing away. Ensure the print adheres to the garment as you peel.

What to do if the transfer lifts
If the transfer lifts off the garment while peeling: Reposition the transfer and ensure it is flat. Re-press for a few seconds with firm pressure. Wait for the transfer to cool to lukewarm and try peeling again.

Using an iron?
If you're using an iron, check out this article for detailed instructions.