OK to give away, not as much for selling

While the print is just fine and rather decent, although visible dithery, the physical product has couple of negs: - the acrylic sheet's protective blue-colored foil is still on the pins and is far from easy to grab hold of to peel it off, so some additional labor investment is needed to make these look good and not damage them by whatever means you choose to remove the foil. - the laser cut crylic has rough sharp edges on both the upper and the lower side, which sometimes catch and pull on a fabric thread. - the centering of the metal pin backing is hit and miss, don't rely on it being perfectly in the middle of the object. - the centering of the metal pin on the metal backing is even a bigger wild card. These are sometimes almost touching the edge of the backing and in such a case the rubber clutch is very visibly sitting wrong and that piece is basically a throwaway.